If there is a gap between the cabinet and the side wall of the recess, fill it with washers or shims so you can tighten the screw fully. But since your cabinet will be in a recess you can also drill one or two additional holes through the side of the cabinet into the side wall, using suitable anchors there and screws to add support for the cabinet using its side wall. Use the side wall: Your problem is the back of the cabinet is just a flimsy decorative panel, you can only use the side panels for mounting. You can also use a short drill extension (10cm) to reduce the angle a little, rather than a very long extension that takes you entirely out of the recess. The side wall is 40cm deep on the one side and 20-25cm deep on the other side.ĭrill at an angle: Just use a longer drill, anchor, and screw to achieve more depth into the brick. The cupboard looks like on this picture and the loops on the back of the cupboard look similar to those. For mounting I'm using Fischer Wall Plugs 55010 with corresponding-size L-shaped hooks. The wall is some depth of plaster (I'm guessing 1-2cm) over red bricks. I don't know how valid this concern is since this is a second time in my lifetime when I mount something on a wall with a drill. The drill bit is long enough to drill the hole at that angle without obstruction but I'm afraid it could negatively impact the load-bearing ability of the wall plugs. The possible solution I have is to drill the hole at an angle, at 70-60 degrees horizontally instead of the usual 90 degrees. I need to drill a hole for a screw anchor 2,5cm from the concave corner, but the drill I have is too wide to fit in that corner. I prefer to not modify the cabinet itself, as my (shady) modification most likely won't handle the load and I prefer not risking it with 4 cats in the house. This is a problem, because the drill I have is too wide to drill this close to the corner without the wall on the side getting in the way. Normally I wouldn't have a problem mounting it, however because I'm mounting it inside a recess, after measuring everything it turns out the furthest I can drill from the corner wall to still fit the hook inside the loop is 2,5cm. The cupboard has two rectangular loops on either side screwed to the back for hanging it on a hook. One of the cupboards stands on the floor in the recess and I wish to mount the second one on the wall above it. In the kitchen I have an 80cm wide recess that perfectly fit with my 80cm wide x 72cm tall cupboards I got as a gift when moving in.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |